2022-09-21 16:18:52.807

High-quality road stud reflector factory share the installation method of Wholesale road stud reflector Manufacturers china

As a high-quality road stud reflector factory, based on years of construction experience and continuous attempts in practice, high-quality road stud reflector factory has summarized his own set of reasonable installation methods for Wholesale road stud reflector Manufacturers china, which has achieved good results and is willing to share with you. The steps are as follows:

1. The installation of road Wholesale road stud reflector Manufacturers china and the installation of safety isolation facilities are very important, and we hope that you can not ignore it. In the whole dynamic construction process, no matter whether it is a new road or a road that has been opened to traffic, all people should be in the safety facilities. For example, the ratio of safety personnel to installation personnel should be 1:1 in the construction of roads that are open to traffic. The ratio of safety personnel to installation personnel shall be 1:3 for the construction of sections not open to traffic

2. Determine the installation position of Wholesale road stud reflector Manufacturers china to ensure that the installation position of the road nail reflector is flat. For the road surface with expansion, cracks and unevenness, the road surface shall be leveled in advance;

3. Clean the installation position of the road nail reflector with a brush, and ensure that the installation position is dry;

4. Apply proper amount of glue evenly on the installation of Wholesale road stud reflector Manufacturers china;

5. Install Wholesale road stud reflector Manufacturers china firmly on the installation position to ensure the correct direction. If there is too much glue, be sure to clean it up;

6. In case of installation of cast aluminum road nail reflector, ensure that the hole depth is 1cm greater than the nail foot depth, and the hole diameter is 2mm greater than the nail foot diameter;

7. Patrol inspection shall be conducted within two hours after the installation of Wholesale road stud reflector Manufacturers china to ensure that Wholesale road stud reflector Manufacturers china are not installed reversely, askew or pressed askew.

8. After Wholesale road stud reflector Manufacturers china is installed and cured for 4 hours, remove the installation isolation facilities.

The installation of Wholesale road stud reflector Manufacturers china is not a complicated matter, but there are many details to pay attention to. These details play a very important role in ensuring the installation quality requirements and service life of Wholesale road stud reflector Manufacturers china.

keyword:

quality road stud reflector,road stud reflector factory,Wholesale road stud reflector,road stud reflector Manufacturers china,road stud reflector

High-quality road stud reflector factory share the installation method of Wholesale road stud reflector Manufacturers china

Relevant news